Photo by Pascal Baudar

This is an old traditional European recipe for making wine with elderflower. In Southern California we have Mexican elders (Sambucus mexicana) at low altitudes and the regular elder (S. nigra) in the mountains. One of the peculiarities of the Mexican elder is the fact that the flowers can be smaller, usually half to a quarter the size of the regular elder, which changes the recipe a bit. 

I don’t know why the wine is called a champagne—perhaps it’s due to the color and the fact that it’s bubbly. The old recipes make no mention of adding yeast, because it’s present on the flowers. I’ve had moderate success (probably around 70 percent) with spontaneous fermentation from the flowers, so these days I usually add some champagne or wine yeast if I don’t see any signs of fermentation after a couple of days. 

30 large Mexican elderflower heads or 20 regular elderflower heads 

1 gallon (3.78 L)

3 cups (500–600 g) white sugar

3–4 lemons, zested and sliced

2 tablespoons (30 ml) vinegar (I use apple cider vinegar)

Champagne or wine yeast (optional—flowers should have wild yeast) 

Pick the elderflowers when they’re fresh and full of pollen. Fresh Mexican elderflowers look a bit greenish, while the older flowers are whiter. You’ll discover very quickly that elderflowers are loaded with little bugs. My solution to get rid of (most of) them is to place the flowers in a bowl outdoors for about an hour; the little bugs will vacate. You can’t really remove them all at this point, but as you strain your solution later on, it will take care of the remaining ones. 

Place the water in a container, add the sugar, and stir with a clean spoon to make sure it’s dissolved. 

Add the lemon zest and lemon slices, the elderflowers (remove as much of the stems as you can without going crazy about it), and the vinegar to the container and stir briefly with a clean spoon. Some people add commercial yeast at this stage. 

Close the container, but not so tight that fermentation gases can’t escape. You can also place a clean towel on top. Let the mixture stand for anywhere from 24 to 48 hours. If you didn’t use yeast, you should see some bubbles after 48 hours, indicating that the fermentation from wild yeast is active. If this doesn’t occur, then add some yeast at this stage. Using a clean spoon, make sure that you stir the liquid for a few seconds three or four times a day during this process. 

Strain the liquid (after 48 hours if additional yeast was necessary) into your fermenting vessel (bottle or bucket). Let the fermentation go for another 4 days. Using a layered cheesecloth when straining the liquid removes any remaining little bugs.

Your final step is to bottle your champagne in recycled soda bottles or swing-top glass bottles. Let it ferment for a week before enjoying. I like to check the pressure from time to time by unscrewing the bottle slightly to make sure it’s not excessive. 

Recipe and photo by Pascal Bauder, courtesy of Storey Press.